MIMAKI TS30-1300 - Print Mode Settings; Print Quality Settings

3-8
Setting print mode
Upon the setting of the print mode, set each item for printing as follows.
• Print quality (DRAFT) : Setting the print quality in the DRAFT mode (Resolution in the scanning
direction: 540dpi)
• Print quality (FINE) : Setting the print quality in the FINE mode (Resolution in the scanning direc-
tion: 720dpi)
• Scanning direction : Setting the printing direction
• Logical-seek : Setting "ON/OFF" of Logical-seek
Setting of the print quality
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing
then press the key.
4
Select [PRINT MODE] by pressing the
keys.
5
Press the key.
6
Select an item to be set.
(1) Select [DRAFT QUALITY] or [FINE QUALITY] ([DRAFT QUALITY] is selected here.) by
pressing the keys.
(2) Press the key.
7
Select the print quality by pressing the
keys.
• Set value : STD / FAST / FINE
• Press the key to terminate the setting at this then proceed to the step10.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
PR I NT MODE <e n t >
[1]PRINT MODE
DRAFT QUAL I TY <e n t >
[1]PRINT MODE
DRAFT q u a l i t y :
S TD .