Setting media compensation
3-7
3
Convenient use
When you need to correct the media feed during printing
The media feeding amount can be corrected even in the remote mode or when printing image data.
1
Press the key in the remote mode.
2
Press the key.
3
Enter the correction amount with and key.
• Correction amount : -500 to 500
• The value entered here will be reflected on the correction amount immediately.
4
Press the key.
• The value entered here will be invalid when pressing
key in stead of key.
5
Press the key.
• The changed value is registered.
• The value entered here will be valid temporarily when
pressing key in stead of key. (If
performing media detection again or turning OFF the
power supply, the correction value will be cleared.)
FEED COMPENSAT I ON .
0
*REMOTE. 1* [ #01 ]
**.**mm
FEED COMPENSAT I ON .
SAVE :
e
nt
*REMOTE. 1+* [ #01 ]
**.**mm
This indicates that the media cor-
rection was performed in the
remote mode.
To Next Page
Loading...
