MIMAKI TS30-1300 - Warning Messages

5-7
Warning / Error Messages
5
Troubleshooting
Message Cause Solution
There is a problem with installed ink
cartridges.
Check the content of the warning details in
the guidance function.
The ink of the ink cartridge has
been nearly used up.
Replace the cartridge generating the
warning with a new one.
The ink of the ink cartridge has
been completely used up.
Replace the cartridge generating the
warning with a new one.
The ink cartridge is not MIMAKI
genuine.
Replace the cartridge generating the
warning with a MIMAKI genuine.
The IC chip of the ink cartridge can-
not be read normally.
Remove the cartridge generating the
warning once and install it again.
If the same warning message still
appears, contact your local distributor to
call for service.
The ink of the ink cartridge is differ-
ent in type from the ink currently
supplied.
Check the ink type of the cartridge gener-
ating the warning.
The ink of the ink cartridge is differ-
ent in color from the ink currently
supplied.
Check the ink color of the cartridge gener-
ating the warning.
There is trouble with an installed ink
cartridge.
Check the cartridge generating the warn-
ing.
An ink cartridge has not been
installed in the slot.
Install an appropriate cartridge in the slot
generating the warning.
The specified expiration date of an
ink cartridge has passed.
Replace the cartridge generating the
warning with a new one.
The cartridge may be used until one
month passes after the specified expira-
tion date.
The expiration date of an ink car-
tridge has passed (one month has
passed after the specified expiration
date).
The red LED blinks. Replace the cartridge
generating the warning with a new one.
The cartridge may be used until two
months pass after the specified expiration
date.
The expiration date of an ink car-
tridge has passed (two months
have passed after the specified
expiration date).
Replace the cartridge generating the
warning with a new one.
Remaining amount of ink in an ink
cartridge is zero.
The waste ink tank is nearly full.
Replace the waste ink tank then execute
[MAINTENANCE]-[Ink Tank Exchange].
( P.4-36)
<LOCAL. 1> !CAR[ #01 ]
*REMOTE. 1* !CAR[#01 ]
INK NEAR END
MMBB ----
INK END
---- YYKK
NON-ORIGINAL INK
---- YYKK
WRO N G I N K I C
---- YYKK
Kind of INK
---- ----
Co l o r o f INK
---- ----
WR O N G C A R T R I D G E
---- ----
NO CARTR I DGE
---- ----
Exp i r a t i on
---- ----
Exp i r a t i on : 1MONTH
---- ----
Exp i r a t i on : 2MONTH
---- ----
INK REMAIN ZERO
---- ----
<LOCAL. 1> [ #01 ]
Check was te i nk<MNT>