MIMAKI TS30-1300 - Setting the Printing Origin

Setting medias
2-15
2
Basic Operations
Changing the printing origin
The position of the printing origin can be changed.
Moving the LED pointer to the changing position and deciding the position.
1
In the local mode, press the
keys.
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by
pressing the keys.
• Select the carriage and media, moving the point with the
keys.
3
After determining the origin, press the
key.
• The printing origin is changed.
Typical setting position of printing origin
The printing origin in the depth direction (X') is positioned at about 40 mm rearward from the cutting line.
The printing origin in the scanning direction (Y') is positioned at 15 mm from the right end of the media.
The value in the scanning direction (Y') can be changed using [MARGIN] in FUNCTION mode.
This can be changed by using the Jog key.
• The origin position set above misaligns with the feeding direction of a media by a few centime-
ters. Turn [FEED ORIGIN] “ON” in setup mode to fit the origin to the correct light position of
LED pointer. ( P.3-4)
OR I G I N SETUP
0.0 ----
OR I G I N SETUP
0.0 0.0
Origin
(Length)
Origin
(Width)
OR I G I N SETUP
** ORIGIN **
Cutting line
About 40 mm
(X')
15 mm
(Y')