3-16
Setting Auto cleaning
The machine is settable so that the head cleaning is automatically carried out when printing is completed for
the set length.
At the completion of printing, the machine counts the length printed after the previous head cleaning and
performs the cleaning automatically if required.
Reliable output results are always ensured if the heads are always kept clean.
The first cleaning is performed immediately before the first printing after the machine is started. Then sub-
sequent cleaning is performed every printing on the specified length of media.
When operation interval is 1000 mm (example)
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing
then press the key.
4
Select [AUTO CLEANING] by pressing the
keys.
5
Press the key.
6
Select “ON” by pressing the keys.
• Proceed to the step 9 when “OFF” is selected.
Print length : 1.6 m Cleaning (3rd time)
Print length : 0.0 m Cleaning (1st time)
Print length : 0.8 m No cleaning
Print length : 1.6 m Cleaning (2nd time)
Print length : 0.8 m No cleaning
When five copies of an image 80 cm long are
printed in series, cleaning is repeated before print-
ing each of the 1st, 3rd, and 5th copies.
[1]
AUTO CREAN I NG <e n t >
[1]AUTO CREANING
SETUP :
O
FF
[1]AUTO CREANING
SETUP :
O
N
To Next Page
Loading...
