MIMAKI TS30-1300 - Media Detection Setup

3-20
Setting media detection
Set the method for detecting a media when the media is set and the detecting type when the media is cut.
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing
then press the key.
4
Select [MEDIA DETECT] by pressing the
keys.
5
Press the key.
6
Press the key.
• The setting display for the media detection is displayed.
7
Select the set value by pressing the keys.
SELECT : Select either a roll media or leaf media by pressing the keys when the
media is detected.
WIDTH : The width of media is only detected without any key input when the media is
detected.(Detecting is started automatically by lowering the clamp lever.)
8
Press the key.
9
Select [CUTTING DETECT] by pressing the
key.
10
Press the key.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
MED I A DETECT < e n t >
[1]MEDIA DETECT
DETECT METHOD <e n t >
[1]MEDIA DETECT
DETECT METHOD : S ELECT
[1]MEDIA DETECT
DETECT METHOD <e n t >
[1]MEDIA DETECT
CUTT I NG DETECT < e n t >
[1]MEDIA DETECT
DETECT :
B OTH EDGE