4-10
Cleaning the ink discharge passage (PUMP TUBE WASH)
Perform washing of the ink discharge passage (the pump tube) periodically to prevent ink from clogging due
to the coagulation of ink within the ink discharge passage.
1
Press the key in the local mode.
2
Select [PUMP TUBE WASH] by pressing the
keys.
3
Press the key.
• The carriage moves onto the platen.
• Repeat the idle absorbing operation (Absorbing for 5 sec-
onds and interrupting for 10 seconds) until washing works
are completed.
4
Open the front cover.
5
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill up the cap with cleaning solution on the verge
of overflow from the cap.
• When the following messages are indicated, check the waste ink tank, and then operate it,
referring to P.4-34 “If Waste ink tank confirming message is displayed” according to the situa-
tion.
Con f i rm a was t e tank
Con t i nue< >Exchange
Con f i rm a was t e tank
Exchange :
e
nt
ST . MA I NTENANCE
CARR I AGE OUT < e n t >
ST . MA I NTENANCE
PUMP TUBE WASH <e n t >
ST . MA I NTENANCE
COMP L ETED : e n t
To Next Page
Loading...
