MIMAKI TS30-1300 - Cleaning During Printing Setup

3-18
Setting cleaning while printing
Set it whether the head cleaning is carried out automatically during printing or not.
Upon cleaning during printing, set the cleaning interval to the length printed.
The printing is interrupted each in the set length and the head cleaning is carried out automatically.
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing
then press the key.
4
Select [Print.CLEANING] by pressing the
keys.
5
Press the key.
6
Select “ON” by pressing the keys.
• Proceed to the step 9 when “OFF” is selected.
7
Press the key.
8
Set an interval of cleaning and cleaning type
by pressing the keys.
Item selecting : by the keys
Interval and Type setting : by the keys
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
Pr int .CLEANING <ent>
[1]Pr int.CLEANIN
SETUP : O FF
[1]Pr int.CLEANIN
SETUP : O N
INTERVAL :TYPE
1 000mm : N ORMAL
INTERVAL :TYPE
1 000mm : N ORMAL
Interval :
10 to 10000mm
Type : NORMAL
SOFT
HARD