5-8
Error messages
When an error message is displayed, eliminate the error according to the chart below.
If the same error message appears again, contact your dealer or an office of MIMAKI to call for service.
Message Cause Solution
An error occurred in the circuit
board system. (ROM)
Turn off the power to the machine and turn
it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error occurred in the circuit
board system. (RAM)
An error occurred in the circuit
board system. (POWER +5V)
An error occurred in the circuit
board system. (POWER +24V)
An error occurred in the circuit
board system. (POWER +42V)
An error occurred in the circuit
board system. (F-ROM)
An error occurred in the circuit
board system. (SD-RAM)
An error in heads was detected.
(Abnormal temperature was
detected.)
An error in heads was detected.
(Abnormal voltage was detected.)
An error occurred in the linear
encoder. (Counting was unable. )
An error occurred in the linear
encoder. (Error in the mounting
direction.)
An error occurred in the linear
encoder. (Read-out count error)
An error occurred in the circuit
board system.
(FPGA PDC)
An error occurred in the circuit
board system.
(FPGA HDC)
The machine received some data
other than command data.
Securely connect the interface cable in
position.
Use an interface cable conforming to the
specifications.
***** ERROR 01 *****
MA I N ROM
***** ERROR 02 *****
MA I N RAM
***** ERROR 03 *****
POWER + 5 V
***** ERROR 03 *****
POWER + 2 4 V
***** ERROR 03 *****
POWER + 4 2 V
***** ERROR 04 *****
F-ROM
***** ERROR 06 *****
SD - RAM
***** ERROR 07 *****
HEAD (----)
***** ERROR 07 *****
VOLTAGE (----)
***** ERROR 08 *****
L i n e a r ENCODER : SENSOR
***** ERROR 08 *****
L i nearENCODER
:
DIR.
***** ERROR 08 *****
L i n e a r ENCODER : COUNT
***** ERROR 09 *****
FPGA ERROR
***** ERROR 09 *****
HDC ERROR (----)
***** ERROR 10 *****
COMMAND ERROR
To Next Page
Loading...
