4-8
Washing of Head nozzle
Perform cleaning of the nozzles in the heads to prevent them being clogged with coagulated ink.
1
Press the key in the local mode.
2
Select [NOZZLE WASH] by pressing the
keys.
3
Press the key.
• The carriage moves onto the platen.
4
Clean the wiper and the bracket.
(1) Open the front cover then pull out it by holding projections at both ends of the wiper.
(2) Clean it with a clean stick dipped in the cleaning solution. (SPC-0137)
(3) Insert it in the original position by holding the projections at both ends of the wiper.
5
Press the key.
Make sure the fol-
lowings in advance.
Is [NEAR END] or [INK END] displayed ?
• The cleaning solution or ink is absorbed in washing.
At this time, washing is unable to operate if the ink end or near-end is
detected.
• Replace it with a cartridge undetected for the ink end or the like.
ST . MA I NTENANCE
CARR I AGE OUT < e n t >
ST . MA I NTENANCE
NOZ Z L E WASH < e n t >
WI PER CLEAN I NG
COMP L ETED ( NEXT ) : e n t
Fi l l the l iquid
COMP L ETED ( NEXT ) : e n t
To Next Page
Loading...
