3-3
User type
3
Convenient use
List of functions
This section describes the outline of each SET UP function registerable to the user type and the setting
value. The underlined has been set when purchased.
Function name Set value Outline
MEDIA COMP. ( P.3-5) -255 ~ 0 ~ 255
Prints a pattern to correct the
feeding rate of media and cor-
rects it.
PRINT
MODE
(P.3-8)
DRAFT Quality STD
/ FAST / FINE
Sets a print quality level and
printing direction.
FINE Quality STD
/ FAST / FINE
SCAN DIRECTION Bi-D
/ Uni-D
LOGICAL SEEK ON
/ OFF
WhiteLay Print OFF
/ ON (LEVEL 1~3)
INK LAYERS ( P.3-22) 1
~ 9
Sets the number of layers in
which ink is to be applied.
DRYING
TIME
(P.3-12)
SCAN 0.0
~ 19.9 sec
Sets the time to wait for ink
drying.
Draw. END 0
~ 999 sec
AUTO CUT ( P.3-22) ON / OFF
Cuts the media automatically
after printing.
PRE-FEED ( P.3-22) ON / OFF
Feeds the media back and
forth before printing.
When sticky media is used,
select ON.
MARGIN
(P.3-13)
LEFT -10 ~ 0
~ 85mm (1mm unit) Sets a non-printing area along
the right and left edges of the
media.
RIGHT -10 ~ 0
~ 85mm (1mm unit)
COLOR PATTERN ( P.3-22) ON / OFF
Prints a color pattern for nozzle
missing check near the right
edge of the media.
REFRESH ( P.3-22)
Level 0 (Refresh interval long)
~ 3 (Refresh interval short)
Refreshes the print heads dur-
ing printing.
VACUUM ( P.3-22)
OFF / STANDARD / WEAK /
Little WEAK / STRONG
Sets the absorbability of the
media.
FeedSPEED LEVEL ( P.3-22)
10 ~ 100
~ 200%
10%6mm/sec
100%60mm/sec
200%120mm/sec
Changes the media feeding
speed in printing.
To Next Page
Loading...
