2-18
Drawing data
Starting the print
1
Set the media. ( P.2-6)
2
Press the key in the local mode.
• It enters the remote mode and enables to receive the
data from the PC.
3
Send the drawing data from the PC.
• The ACTIVE lamp blinks and the drawing condi-
tion is displayed.
• For the method of data transmission, refer to the
instruction manual for the output software.
4
This machine starts printing.
• The printing speed may vary due to the set media
width or the position of print origin even when the
same data is printed, depending on resolution.
• When a roll media is used, rewind the roll media by hands prior to printing so that it is set in the
tightened condition. The loosened may result in failures of the image quality.
*REMOTE. 1* 720x720
16.Bd .Vd . x2 xx . xxm
Resolution : 360 /540 /720
/1440 DPI
Number of passes
The length of
media drawn
Scan direction
Ud : Unidirectional
Bd : Bidirectional
Data type
Vd : Variable data
Nd : Normal data
Scanning speed
x1 : Standard
speed
x2 : Double
speed
To Next Page
Loading...
