MIMAKI TS30-1300 - Ink Drying Time Settings

3-12
Setting drying time
Upon the setting of drying time, set each item for ink drying as follows.
• SCAN : Set the time to wait for ink drying after each pass. During bidirectional printing, the
machine stops temporarily after every scanning back and forth.
• Draw. END : Set the time to wait for ink drying after completion of printing.
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing
then press the key.
4
Select [DRYING TIME] by pressing the
keys.
5
Press the key.
6
Set the drying time by pressing the
keys.
Item selecting: by the keys
Time setting : by the keys
7
Press the key.
8
Press the key several times to end.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
DRY I NG T I ME < e n t >
SCAN : D r aw . END
0 .0s : 0 s
SCAN : D r aw . END
0 .0s : 0 s
Scanning :
0.0 to 19.9 seconds
Post-printing :
0 to 999 seconds
[1]
DRY I NG T I ME < e n t >