4-30
Print the media remaining amount
You can print the current media remaining amount.
1
In the local mode, press the
keys.
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by
pressing the keys.
• Select the carriage and media, moving the point with the
keys.
• When not changing the origin, proceed to the Step 3 with-
out pressing
, , and key.
• When pressing key here, the origin will be
changed and it will return to the local mode.
3
Press the key.
• When pressing , , and key, the
screen will return to the Step 2 screen.
• When pressing key, it will return to the local
mode.
4
Press the key.
• Start printing of the media remaining amount.
• When the printing completes, it will return to the local mode.
• Set [MEDIA RESIDUAL] to “ON”. ( P.4-29)
• When changing the media, it is recommended to print the remaining amount to the currently
used media. If you print the media remaining amount in advance, for using the changed
media, you can enter the correct value in the screen for entering media remaining amount
after detecting the media ( P.2-12).
• When printing after changing the origin, the origin set here will be valid when printing data sub-
sequently.
OR I G I N SETUP
0.0 0.0
Origin
(Length)
Origin
(Width)
MED I A RES I DUA L DRAW
<ENT>
To Next Page
Loading...
