MIMAKI TS30-1300 - Page 123

4-33
Other maintenance functions
4
Routine Maintenance
3
Press the key.
4
Press the key to set the operation
time.
• Set value : OFF (disabled) or 12 to 120 hours
5
Press the key.
6
Press the key several times to end the setting.
Note on head height adjustment
When you use sublimation transfer ink, if you make the head height 5mm (H range/ thick), it may affect the
drawing quality.
It is recommended to use with making head height 4mm (H range/ thin) or L range.
• If the head height is 5mm, the right message may be dis-
played at starting of drawing or at turning on the power
supply.
When you press the key, the message goes out.
• You can check the current head height with the procedures below:
(1) Press the key in LOCAL.
(2) Press the key several times to display “Head height” and then check.
“HEAD HEIGHT:Thin” = The head height is 2mm.
“HEAD HEIGHT:Thick” = The head height is 3mm.
“HEAD HEIGHT:Thin+” = The head height is 4mm.
“HEAD HEIGHT:Thick+” = The head height is 5mm.
• For the head height adjustment method, refer to Chapter 2 “Adjusting the head height” of
the TS30 Series User Manual.
• Contact to our sales office for switching L range <-> H range by field person.
ROUT I NE SETUP
Sub - INK WARNING=
7 2h
ROUT I NE SETUP
Sub - INK WARNING=
8 4h
ROUT I NE SETUP
Sub - INK WARNING<en t >
NOT RECOMMENDED ! !
CHK . HEAD HE I GHT : e n t