4-6
5
Clean the wiper slider.
• Wipe ink sticking to the wiper slider off with a
clean stick dipped in the cleaning solution.
6
Set the wiper at the original position.
• Insert the wiper by holding both ends of the wiper.
7
Clean the cap rubber and wiper cover.
• Wipe ink sticking to the cap rubber and the wiper
cover off with a clean stick dipped in the cleaning
solution.
8
Close the front cover then press the
key.
• After performing the initial operation, the machine
returns to LOCAL mode.
Performing the station maintenance without key
ST.MAINTENANCE is selectable from the local mode by using the key, not by pressing the
key.
Press the
key in the local
mode.
Select [MAINTE-
NANCE] by press-
ing the
keys.
Press the key twice.
• It becomes the same condition as the
key is pressed from the local
mode.
( COVER OPEN )
PRESS <ENT> KEY
*Be i ng In i t i a l i zed*
PLEASE WA I T
To Next Page
Loading...
