Chapter 1 Before Use
1-8
Capping station
The capping station consists of the ink caps, the wiper for
cleaning the heads, etc.
The ink caps prevent the nozzles in the heads from drying
up.
The wiper cleans the nozzles in the heads.
The wiper is consumable.If the wiper is deformed or the
media is stained, replace the wiper with a new one.
( P.4-20)
Pinch rollers and Feed rollers
This machine retains the media with the pinch rollers and
feed rollers. During printing operation, the feed rollers
feed the media forward.
Connecting Cables
Connecting USB2.0 Interface Cable
Connect the PC and this machine with the USB2.0
interface cable.
Notes on USB 2.0 Interface
When two or more UJV55-320 machines are
connected to one personal computer
When two or more UJV55-320 machines are connected to
one personal computer, the personal computer may not
recognize all the UJV55-320 machines normally.
Reconnect the unrecognized UJV55-320 machine to
another USB port, if available, and check to see if it is
recognized.If the UJV55-320 machine is not recognized
by the newly connected USB port, use USB 2.0 repeater
cables available on the market.
• Be sure to wear the attached goggles in cleaning
within the capping station to protect your eyes
against ink. Otherwise, you may get ink in your
eyes.
• If the capping station is subjected to sunlight or
artificial light, the ink inside the capping station will
become cured, resulting in reduced image quality
and malfunctions. Therefore, the cover should be
closed as soon as possible after maintenance is
complete.
• Keep the pinch rollers lifted up when this machine
is not in use. If the pinch rollers are left lowered for
an extended period of time, they can be deformed
and fail to securely retain the media.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our
office when the USB2.0 interface is not attached to
the PC.
• Your RIP must be compatible with USB 2.0.
To Next Page
Loading...
