2-18
Setting media by using the
narrow take-up device
If you are using PVC or photo paper as the media, take up
the media set in the roll holder by using the narrow take-
up device, as described below.
Set the settings of Feeding unit and
Take-up unit of Machine Setup to “OFF”
1
By referring to P.3-14, set the settings of
Feeding unit and Take-up unit to “OFF”.
Lower the tension bar located on the front of the
machine to its lowest position to remove the roll shaft
You have to complete the steps described below before
using the narrow take-up device.
Failure to do so could cause machine damage.
1
Lower the tension bar located on the front
of the machine to its lowest position.
(1) Unlock the tension bar.
(2) Lower the tension bar to its lowest position,
and then lock it.
Set media by using the narrow take-
up device
1
To use the narrow take-up device, you must
first complete the following two steps:
• “Adjusting the Head Height and Jam sensor
Height”
• “Note for media setting”
2
Follow the steps 2 to 15 of “Setting a
narrow roll media”.( P.2-12)
3
Feed the media to the narrow take-up
device.
(1) Pressing [], feed the media until the paper
core of the narrow take-up device is hidden.
• Check the media end is not caught into the
slot on the platen, and feed the media.
4
Fix the media to the paper core.
(1) Fix the media in the center of the paper core
with adhesive tape.
You have to complete the following steps before
taking up the media by using the narrow take-up
device.
(1) Set “Setting Feeding unit” and “Setting Take-
up unit” of Machine Setup to “OFF”.
(2) Lower the tension bar located on the front of
the machine to its lowest position.
(3) Remove the roll shaft that is used to take up
wide media.
• If you do not set the settings of Feeding unit and
Take-up unit to “OFF”, the narrow take-up device
might not be able to take up the printed media.
• With the narrow take-up
device, the media is routed as
shown in the figure to the
right.
No tension bar is used.
Roll up with the print-
side outside.
Ta pe
Recommendation
Roll up with the print-
side inside.
Paper core
To Next Page
Loading...
