3-15
3
2
2
Setting the Display of Media Remain
Whether the screen displays the remaining amount of a
media is set.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press to select “Media Remain”,
and press the key.
4
Press to select ON/OFF.
5
Press the key.
6
Press the key several times to
end the setting.
Setting Time
You can set time of your country (time difference).
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press to select “TIME” , and
press the key.
4
Press
(
)
.
• You will be able to change the time.
5
Press to enter time, and
press the key.
• Year/Month/Day/Time selecting:
by the [][] keys.
• Year/Month/Day/Time inputting:
by the [][] keys.
6
Press the key several times to
end the setting.
Setting Unit (Temperature/ Length)
Units used by this machine are set.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press the
(>>)
.
4
Press to select “Unit/Temp” or
“Unit/Length”, and press the key.
5
Press to select a set value, and
press the key.
• Set value of tempture :°C / °F
• Set value of length : mm / inch
6
Press the key several times to
end the setting.
Setting a Key Buzzer
You can turn off the buzzer sound when pressing the key.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press the
(>>)
.
4
Press to select “Key Buzzer” ,
and press the key.
5
Press to select a set value, and
press the key.
• Set value : ON/ OFF
6
Press the key several times to
end the setting.
When the media
remaining amount
display is turned to
"ON"
the remaining amount of a media is
displayed in Remote.
(However, when a leaf media is used,
the length of the media to be printed is
displayed.)
When the media
remaining amount
display is turned to
"OFF"
the remaining amount of a media is not
displayed in the Remote.
• The displayed amount of a media is a rough
indication. It may be different from the actual
remaining amount.
• The amount of a media that has been fed by the
printing and jog keys is reflected in the remaining
amount of a media.
• The length of a media (initial value of the
remaining amount) is entered when a roll media is
detected.( P.2-10)
• The setting configured here does not become
effective unless media detection is performed after
the setting has been complete.
• As for the time difference, -20 hours to +4 hours
can be set.
• The buzzer sound is not disabled for errors,
warnings and/or operation completion even if this
setting is set to “OFF”.
To Next Page
Loading...
