MIMAKI UJV55-320 - Setting Leaf Media

2-20
(2) In the same manner, fix the left side and right
side of the media.
• Pull roll media evenly for right and left, check
that there is no slack or waviness on the
media, and paste tape in numerical order.
• When you place the tape, consider the
rolling-up direction.
5
Roll up the media.
• By using the switch and the button on the narrow
take-up device, select a media taking-up direction
and then take up the media.
6
Follow the steps 13 and later of “Setting
two narrow roll media (twin rolls)”.
( P.2-15)
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Open the front cover and raise the clamp
lever.
2
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
3
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
• With the narrow take-up
device, the media is routed as
shown in the figure to the
right.
No tension bar is used.
Direction
selector
switch
Front side
(FORWARD)
The take-up device winds the media
with the printed side facing in.
Rear side
(REVERSE)
The take-up device winds the media
with the printed side facing out.
ON/OFF button
Turns the winding motion on/off.
(When you press the button and
operate the take-up device, the device
keeps taking up the media until you
press the button again.
*1
)
*1. You can also change the setting so that the taking-up operation only
lasts while the ON/OFF button is being pressed. For details, refer to
“Setting Take-up unit” in machine settings.
ON/OFF button
Direction selector switch
Clamp lever
Front cover
Media Press