MIMAKI UJV55-320 - Set Media by Using the Narrow Take-Up Device (Twin Rolls)

2-19
2
2
2
2
(2) In the same manner, fix the left side and right
side of the media.
• Pull roll media evenly for right and left, check
that there is no slack or waviness on the
media, and paste tape in numerical order.
• When you place the tape, consider the
rolling-up direction.
5
Roll up the media.
• By using the switch and the button on the narrow
take-up device, select a media taking-up direction
and then take up the media.
6
Follow the steps 22 and later of “Setting a
narrow roll media”. ( P.2-12)
Set media by using the narrow take-
up device (twin rolls)
1
To use the narrow take-up device, you must
first complete the following two steps:
• “Adjusting the Head Height and Jam sensor
Height”
• “Note for media setting”
2
Follow the steps 2 to 11 of “Setting two
narrow roll media (twin rolls)”. ( P.2-15)
3
Feed the media to the narrow take-up
device.
(1) Pressing [], feed the media until the paper
core of the narrow take-up device is hidden.
• Check the media end is not caught into the
slot on the platen, and feed the media.
4
Fix the media to the paper core.
(1) Fix the media in the center of the paper core
with adhesive tape.
Direction
selector
switch
Front side
(FORWARD)
The take-up device winds the media
with the printed side facing in.
Rear side
(REVERSE)
The take-up device winds the media
with the printed side facing out.
ON/OFF button
Turns the winding motion on/off.
(When you press the button and
operate the take-up device, the device
keeps taking up the media until you
press the button again.
*1
)
*1. You can also change the setting so that the taking-up operation only
lasts while the ON/OFF button is being pressed. For details, refer to
“Setting Take-up unit” in machine settings.
ON/OFF button
Direction selector switch
Pay attention to the following when printing on
twin rolls.
• Use media having a media width of 1524 mm or
less and a paper core width of 1550 mm or less.
• Set two media having the same properties as
shown below. Otherwise, the printed image quality
will be affected.
Media type, media grade, media width, the
diameter of media to be set (with the same
remaining media amount), and media rolling-up
direction
Roll up with the print-
side outside.
Ta pe
Recommendation
Roll up with the print-
side inside.
Paper core