MIMAKI UJV55-320 - Connecting Power Supply Cable

Chapter 1 Before Use
1-10
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
(1) Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
• Check that "1000Mbps" is displayed for the LAN status
item.
(2) Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
Connecting Power Supply Cable
You are not allowed to install the printer by yourself. Be
sure to request MIMAKI’s service personnel and an
electrician to install the printer.
For power supply connection, this printer uses the Type B
plug and socket in compliance with IEC 60309.
When a socket construction meeting the plug of the power
cable of this printer is required, use the supplied socket
and perform construction between your switchboard and
the socket.
• If "100Mbps", "10Mbps", or "No connect" is
displayed, you cannot print using the LAN.
• If "100Mbps" or "10Mbps" is displayed, you can
use event mail ( Chapter3 “ Setting event mail
function”).
Color Status Condition
Green
ON Connected with 1000BASE-T
OFF Connected without 1000BASE-T
Yellow
ON Link-up
Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000Mbps. Check the specifications
of the PC, device, and cables.
INFORMATION
LAN Status 1000Mbps
• The power supply specifications of this machine is
as below:
Single-phase 200 to 240 Vac 18A (cannot be used
with 100 V system)
• For the power supply to the main body of the
printer, electrical work is required as described
below. Request an electrician to perform electrical
work.
• Socket installation onto the circuit breaker
• Grounding work
• Ensure that a wall outlet is available near the
printer. Also ensure that the power cable can be
easily unplugged whenever necessary.
• To prevent electrical shock hazard, it is prohibited
for anyone other than electrician licensees to
perform the electrical work for this printer.
• Take care not to miswire, which can result in a fire
or an electric shock.
• When any power cable other than the supplied
one is to be used, make sure that the cable is
equivalent to one of the following types. Connect
the cable as shown below.
•VCT-5.5m m
2
x33 cores (600 V)
• UL-AWG10x3C (600V)
Side of the
printer body
Power cable:
UL AWG10 or the
equivalent
Supplied socket
Socket construction
Switchboard
Socket
Socket
construction
Circuit breaker
1φ 200V to 240V 20A
Switchboard