MIMAKI UJV55-320 - Setting of Vacuum Fan; Setting of Print Speed; Setting of MAPS4

3-10
Chapter 3 Setup
Setting of Vacuum Fan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(<<)
.
4
Press to select “Vacuum Fan” ,
and press the key.
5
Press to select a set value, and
press the key.
• Set value : Host/Weak /Standard/ Strong/ OFF
6
If you choose any other option than "OFF"
in step 4, press , choose whether
to constantly operate the vacuum fan, and
press the key
• ON : Vacuum fan is constantly on.
• OFF : Vacuum fan is only on when printing or
performing jog operation.
7
Press the key several times to
end the setting.
Setting of Print Speed
Changes the media feeding speed and scanning spped in
printing.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(<<)
.
4
Press to select “Print Speed” ,
and press the key.
5
Press to select a setting item,
and press the key.
• Set value : Feed Speed / Scan Speed
6
Press to select a set value, and
press the key.
• Set value of “Feed Speed”:10 to 100%
• Set value of “Scan Speed”:70 to 100%
7
Press the key several times to
end the setting.
Setting of MAPS4
If performing media correction does not resolve feeding
stripes, use the MAPS (Mimaki Advanced PassSystem)
function to disperse the pass boundary to make the
feeding stripes less visible.
Setting MAPS4 Function
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(<<)
.
4
Press to select “MAPS4” , and
press the key.
5
Press to select a set value, and
press the key.
• Set value：AUTO/ MANUAL
• If you have selected “MANUAL”, proceed to step
5. Otherwise, proceed to step 9.
6
Press to select the "Pattern”, and
press the key.
7
Press to select the “Type”, and
press the key.
• Set value：Pattern1, Pattern 2 and Pattern 3
8
Press to select the "Smoothing
Lv.”, and press the key.
• When switch the setting 1 to 4 /Temporary or copy
the setting, there is a case that the setting screen
of vacuum fan is displayed.
• Changing the MAPS4 settings may change the
color tone. Check the effects before use.
• MAPS may not be effective depending on image to
be printed. Use it after checking effect in advance.
• MAPS4 effect differs depending on image to be
printed. Change the printing pattern and use it
after checking effect in advance.
 Conditions disabling MAPS function
When the conditions which do not show "MP" in the
display during printing is set, MAPS function is dis-
abled. ( P.2-27)
In addition, by the image to be printed, there is a case
that the effects of the MAPS can not be obtained.