MIMAKI UJV55-320 - Setting a Narrow Roll Media

2-12
Setting a narrow roll media
When you use narrow roll media (up to 1.6m), set the
media on the narrow roll holder.
1
Set the setting of the feeding unit to “OFF”
in “Setting Feeding unit” of the machine
setting. ( P.3-14)
2
Open the front cover and rear cover.
3
Move the media press to outside.
4
Move the roll holder R on the back of this
machine.
• Loosen the roll holder fixing screw and then move
it.
• Move the roll holder to such a position that the
media will be set in the center of this machine.
5
Tighten the fixing screw of roll holder R.
6
Set the roll tables as shown in the figure
and temporarily place the media on top of
the tables.
• Keep a proper space between the tables to
stabilize the media.
7
Insert the paper core into the roll holder R.
8
Loosen the screw of the roll holder C then
insert the holder into the core of the roll
media.
• Push the roll media onto the roll holder until the
roll core is all the way seated.
9
Remove the roll tables
• At the take-up side, set the printed surface to
“involuted”. (If you set it to “revoluted”, it may
adversely affect the media feeding.)
• When setting a media, place the media in the
center of the machine . If the media is set to the
right or left, the media may not be transported
normally.
• The roll holder guide shaft has a mark indicating
the center position. Refer to this mark when
setting.
Front cover
Rear cover
Media Press
Roll holder fixing screw
Roll honder R
• If it is difficult to directly set the media in the roll
holders, temporarily set on the roll tables and then
set the roll holders to make setting easier.
Roll table
Roll stopper