MIMAKI UJV55-320 - Page 39

2-11
2
2
2
2
Remove and use the image quality
confirmation LED light
Image quality confirmation LED light is removable. Please
use when check the finish of the printed matter on work
table and the like.
(1) Turn off the power of the image quality confirmation
LED light and unplug.
• Outlet for the image quality confirmation LED light is
connected to the right side of the machine.
(2) Remove the AC adapter.
• Peel off the magic tape that secures the AC adapter,
then remove the AC adapter.
(3) Remove the LED holder by sliding it, and pulling to
the front side.
(4) Tilt the LED panel on the front.
(5) Remove the LED panel connection cable.
(6) Removing the image quality confirmation LED light.
(7) Place on the work table with the LED light side to
the top and check the print.
Power switch
Magic tape
AC adapter
LED panel holder
LED panel
• Do not remove the LED panel while it is still
connecting the connecting cable. Panel may fall
and will be the cause of damage.