MIMAKI UJV55-320 - Removing the Taken-Up Media

2-21
2
2
2
2
4
Push down the clamp lever and close the
front cover.
• Set the media straight.
5
Press the key.
6
Press the key to select "LEAF" .
• If the [Setting the Display of Media Detection] of
Machine Setup set in “AUTO”( P.3-16), the
machine automatically detects the media width.
7
Setting the Logical Seek.
(1) Press [][] to select the set value.
• Set value : Media/ Data/ Quality
(2) Press the [ENTER] key.
• When [Media Remain] of the Machine Setup is
"ON" ( P.3-15), you are prompted to enter the
media remaining amount. ( P.2-10)
Removing the taken-up media
1
Release the lock of the taking-up tension
bar and lower the tension bar.
2
Open the cover on the left side of the
taking-up shaft and pull the taking-up shaft
forward.
3
Pull out so that the white plastic collar is
inserted into the slot on top of the leg.
4
Remove the roll holder, and take off the
paper core.
Lock