MIMAKI UJV55-320 - Page 29

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Adjusting the Head Height and Jam sensor
Height .......................................................... 2-4
Note for media setting ................................. 2-4
Setting a roll media ..................................... 2-5
Use the image quality confirmation LED
light to check the print ............................... 2-10
Setting a narrow roll media ....................... 2-12
Setting two narrow roll media (twin rolls) .. 2-15
Setting media by using the narrow take-up
device ..........................................................2-18
Set the settings of Feeding unit and Take-up
unit of Machine Setup to “OFF” ................. 2-18
Lower the tension bar located on the front of
the machine to its lowest position to remove
the roll shaft ............................................... 2-18
Set media by using the narrow take-up
device ........................................................ 2-18
Set media by using the narrow take-up device
(twin rolls) ..................................................2-19
Setting leaf media ......................................2-20
Removing the taken-up media ...................2-21
Changing the printing origin .......................2-22
Preparing for the Heaters ............................2-23
Changing the Temperature Settings for the
Heaters ......................................................2-23
Test Printing ................................................2-23
Test Printing ...............................................2-24
Head Cleaning ............................................2-24
About head cleaning ..................................2-24
Perform head cleaning depending on the
test printing result ......................................2-24
Setting of Media Correction .........................2-25
Setting of Media Correction ......................2-25
Correct the ink drop position for bidirectional
printing ........................................................2-26
Printing Data ...............................................2-27
Starting a Printing Operation .....................2-27
Stopping a Printing Operation ....................2-27
Deleting Received Data (Data Clear) ........2-27
Chapter 2
Basic Operations