2-9
2
2
2
2
When take-up the print media using
the paper core
In stead of directly taking-up to the roll shaft, set the paper
core to the roll shaft and take-up to the paper core.
When removing the wound media from the roll shaft, you
can remove the paper core media is wound from the roll
shaft.
1
Open the cover of the take-up device on
the front left side of the machine, and take
out the roll shaft.
2
Through the paper core to the roll shaft,
mount the take-up roll holder at both ends
of the paper core.
3
Replace the roll shaft, close the cover of
the take-up device.
• When cover remains open, an error message is
displayed and you will not be able to operate such
as printing.
4
Refer to “Setting a roll media” on step 16
of P.2-5, and pull out the media until the
paper core.
• Pull out the media so that the right and left are
equalized.
5
Firmly insert the take-up roll holder which
was mounted in Step 2 into the paper core
and fix.
(1) Insert the roll holder (right and left) in a paper
core and tighten with the fixing screw.
(2) Turn the handle of the take-up roll holder to
tightly secure the paper core.
6
Perform the operations in “Setting a roll
media” step 9 and later.
• When you fix the roll holder, please do not lift the
lever of the fixing screws.
When the entire fixing screws are raised above,
screws idle and can not be fixed.
• As the paper core is not idling in the middle of
taking up the media, please tightly secure the
paper core.
• When you fix the paper core, keep it within the
range indicated with the “movable range seal”
attached to the paper core.
To Next Page
Loading...
