Operating Your Analyzer
6-14
z Be sure to keep the sample probe tip away from the tube bottom, otherwise
the aspiration volume may be inaccurate.
z When the aspiration is done, remove the sample tube only when the sample
probe is out of the tube.
1. At the “Count” screen, be sure the System Status area displays “Ready“ and Count
Mode area displays “Whole“.
2. Present the mixed sample to the sample probe so that the tip is well into the tube, and
press the aspirate key. The System Status area will display “Running” and the analyzer
will start aspirating sample.
3. When you hear the beep and the sample probe is out of the tube, remove the sample
tube. The sample probe will retract into the analyzer and the analysis progress will be
displayed on the screen.
4. When the analysis is finished, the result will be displayed on the screen and the sample
ID will automatically increase by 1 and the sample probe will be replaced. And if the auto
print function is enabled, the analysis result will be automatically printed out.
5. Repeat the above steps on other samples.
z If the analyzer detects WBC/RBC clogging or bubbles during the analysis,
the corresponding error messages will be displayed in the upper left corner
of the screen and the results of all the related parameters will be invalidated.
See Chapter 11 Troubleshooting for solutions.
z If the ambient temperature is outside the specified operating range, the
analyzer will alarm you for abnormal ambient temperature and the analysis
results may be unreliable. See Chapter 11 Troubleshooting for solutions.
6.6.3 Special Functions
Automatic saving of analysis results
This analyzer automatically saves maximum 35,000 sample results. When the maximum
number has been reached, the newest result will overwrite the oldest.
To Next Page
Loading...
