Reviewing Sample Results
7-28
SELECT “Review → Search Review → Search Histogram Review” (Figure7-43) to enter
the “Search Histogram Review” screen (Figure7-44). The sample information will be
displayed at the top of the screen, followed by the parameter values and histograms. The
“Location/Total” displayed in the upper right corner of the screen indicates the location of the
current sample result and the total number of the saved sample results.
Figure7-44 “Sample Histogram Review” screen
Browsing sample results
Press [←] or [→] to browse the preceding or following sample result; press [PgUp] or [PgDn]
to jump 6 locations (e.g. jumping from location 1 to location 7 ).
Switching to the “Search Table Review” mode
To switch to the “Search Table Review” mode, press [6]; to switch back to the “Search
Histogram Review” mode, press [6] again.
Jumping to a sample result with known location
Press [1] and a “Goto” window will pop up, as Figure7-45 shows.
To Next Page
Loading...
