Using the QC Programs
8-26
Figure 8-30 System menu
SELECT “Quality Control →Analysis →Table→ File 1” (Figure 8-30) to enter the “
X
Table” screen (Figure8-31). Every screen displays 5 results. The parameter value fallen
outside the expected range will be flagged “H” (higher than the upper limit) or “L” (lower than
the lower limit).
Figure8-31“
X
Table”screen
Browsing
X
analysis results
Press [PgUp] or [PgDn] to review the preceding or following screen.
Deleting QC results
Press [DLE] and a message box will pop up to ask you whether to delete all the QC results
To Next Page
Loading...
