Customizing the Analyzer Software
5-16
Figure 5-20 Selecting parity check
5.5.4 Enabling/disabling handshake
If the “Handshake”function is enabled, the analyzer will send a handshake signal to the host
and wait for the response. If the host does not respond in 8 seconds, the analyzer will abort
the transmission and alarm you for a transmission error. If the “Handshake” function is
disabled, the analyzer will transmit the data without confirming the communication link. To
enable (or disable) the “Handshake” function, SELECT ”Yes” (or ”No”) from the
“Handshake” pull-down list, as Figure 5-21 shows. The “Handshake” function is disabled
by default.
To Next Page
Loading...
