Mindray iMEC8 Vet - 13 Monitoring Temp; Introduction; Safety; Making a Temp Measurement

13-1
13 Monitoring Temp
13.1 Introduction
You can simultaneously monitor two temperature sites using the iMEC monitors.
13.2 Safety
WARNING
 Verify that the probe detection program works correctly before monitoring. Unplug the temperature probe
cable from the T1 or T2 connector, and the monitor can display the message [T1 Sensor Off] or [T2 Sensor
Off] and give alarm tones correctly.
13.3 Making a Temp Measurement
1. Select an appropriate probe for your patient.
2. If you are using a disposable probe, connect the probe to the temperature cable.
3 Plug the probe or temperature cable to the temperature connector.
4. Attach the probe to the patient correctly.
5. Check that the alarm settings are appropriate for this patient.