6-3
The split-screen view covers the lower part of the waveform area and shows HR trend, SpO
2
trend, RR trend, and a
compressed wave (Resp wave or CO
2
wave). At the bottom, there are the following controls:
1. OxyCRG Event
You can enter the [Review] menu by selecting the [OxyCRG Event] button.
2. Trend length list box
In the trend length list box, you can select [1 min], [2 min], [4 min], or [8 min].
3. Setup
Select the [Setup] button to enter the [Setup] menu, in which you can select the parameters for display, the time
length to be saved before and after an event, and the scale of the graphic trends and waveform. The trend area can
display two parameter trends, e.g. HR trend and RR trend, simultaneously.
4. Auto Scale
Select the [Auto Scale] button, and the system automatically adjusts the scaling.
5. Print
Select [Print] to print out the realtime OxyCRG.
6. Record
With this button, you can print out the currently displayed OxyCRG trends by the recorder.
6.4 Viewing Other Patients
6.4.1 Care Group
You can place up to 10 monitors (including telemetry) connected to the same LAN into a Care Group. This lets you:
View information on the monitor screen from another bed in the same Care Group.
Be notified of physiological and technical alarm conditions at the other beds in the same Care Group.
To have a Care Group:
1. Open the [View Other Patient] window by:
Selecting the [Others] QuickKey, or
2
1
3
4
5
6
To Next Page
Loading...