Mindray iMEC8 Vet - Setting the IP Address, Subnet Mask and Gateway

20-4
2. Enter the [IP Address] of wireless AP in the [WLAN Test >>] menu.
3. Click [Connection Test].
The Wi-Fi device used in the monitor is in compliance with IEEE 802.11b/g/n.
20.5.3 Setting the IP Address, Subnet Mask and Gateway
In the [Network Setup] menu, you can set IP address, subnet mask and gateway. You should not change the monitor’s IP
address randomly. If you want to know details about IP address setup, contact the technical personnel in charge of the
CMS.
NOTE
 The design, installation, restruction and maintenance of the wireless network’s distribution shall be
performed by authorized service personnel of our company.
 The existence of obstacles (such as wall) will exert impact on data transferring or even cause network
interruption.
 The Central Monitoring System is capable of connecting up to 32 bedside monitors via the wireless network.