17-4
By selecting the [Record] button, you can print out the currently displayed alarm events by the recorder.
By selecting the [Events List] button, you can view the events list.
17.5 Reviewing Waveforms
In the [Review] menu, select [Full Disclosure] to access the following window.
A. Waveform area B. Parameter area
In this review window:
To review full-disclosure waveforms, you need to save waveforms first. Select [Save Waves >>] and then select the
parameters whose waveforms you want to view. To save full-disclosure waveform, your monitor must be equipped
with a storage card.
To view the waveforms, you can either:
Select or beside the [Scroll] button to move the cursor one step left or right to navigate through the
waveforms, or
Select or to move the cursor one page left or right to navigate through the waveforms.
A time indicating your current position is displayed at the top of the waveform area. Numeric measurement values
corresponding to the cursor location are displayed in the parameter area, and change as the cursor is moved.
You can change the ECG wave gain by selecting [Gain] and then selecting the appropriate setting.
You can change the waveform sweep speed by selecting [Sweep] and then selecting the appropriate setting.
By selecting the [Record] button, you can print out the first three waveforms and measurement numerics by the
recorder.
By selecting or beside the [Event] button, you can position the cursor between events.
A
B
To Next Page
Loading...