Mindray iMEC8 Vet - 20 Other Functions; Analog Output; Exporting the Log; Transferring Data

20-1
20 Other Functions
20.1 Analog Output
The monitor provides analog output signals to accessory equipment via the multifunctional connector on the rear of the
monitor. To obtain analog output signals, connect the accessory equipment such as an oscillograph, etc. to the monitor.
NOTE
 The analog output feature is seldom applied in clinical applications. You can contact your service personnel
for more details.
20.2 Exporting the Log
The monitor stores system status information, including failures, abnormity, and technical alarms, into the log. You can
export the log to a USB drive.
To export the log,
1. Connect a USB drive to the monitor’s USB connector.
2. Select [Main Menu]→[Maintenance >>]→[User Maintenance >>]→enter the required password→[Others >>].
3. Select [Export Log].
20.3 Transferring Data
You can transfer the patient data saved in the monitor to a PC via a crossover network cable or within a LAN for data
management, review or print.
20.3.1 Data Export System
You must install the data export system on the intended PC before performing the data transfer operation. Refer to the
document accompanying the installation CD-ROM for installation instructions.
The data transfer feature supports patient management, data review, data format conversion, print, etc. in addition to
data transfer. Refer to the help file of the system software for more details.