Mindray iMEC8 Vet - Transferring a Patient; Transferring Data from the Monitor to a USB Drive

4-4
4.7 Transferring a Patient
You can transfer patient data between monitors with a USB drive without re-entering the patient demographic
information. Transferring of patient data enables you to understand the patient’s historical condition. The patient data
that can be transferred includes: patient demographics, trend data, alarm events and parameters alarm limits.
Select [Others >>] from [User Maintenance] menu. In the popup menu, you can set [Transferred Data Length]. The
default is [4 h]. You can also set [Data Transfer Method]. The default is [Off].
WARNING
 Do not discharge a patient before the patient is successfully transferred.
 After a patient is successfully transferred, check if the patient settings (especially patient category, paced
status and alarm limits settings, etc) on the monitor are appropriate for this patient.
NOTE
 The system automatically switches on the HR alarm and lethal arrhythmia alarm after transferring the
patient data.
4.7.1 Transferring Data from the Monitor to a USB Drive
1. Select [Main Menu]→[Patient Setup >>].
2. Select [Transfer to Storage Medium]. In the popup menu, select [Ok].
3. Wait until the following message appears: [Transfer to storage medium successful. Please remove the USB
drive.].
4. Remove the USB drive from the monitor.