5-6
2. To take out the double inverters (if installed), pull out all the connectors on the
inverters. Then unscrew the four M2×6 screws.
NOTE
z Pull the connector and avoid damaging the cable when removing the cable
connecting the inverter to the LCD screen.
z When reassembling, make sure you put the insulating cover in place.
z When reassembling, make sure you place the cables connecting the double
inverters (if installed) to the main board underneath the inverter board as shown
in the figure above.
3. Remove the cables connecting the touchscreen board to the main board and
touchscreen. Unscrew the two M3×6 screws and take out the touchscreen board.
To Next Page
Loading...
