5-5
5.4.4 Removing the Alarm LED Board
Unscrew the two PT2×8 screws and take out the alarm LED board. Please notice that
the alarm LED cable is welded on the alarm LED board.
5.4.5 Removing the LCD Assembly
CAUTION
z Do not touch the LCD screen.
z Disassemble the LCD screen in an environment as dust-free as possible.
1. To take out the single inverter (if installed), remove the cables connecting the inverter
to the LCD screen and to the main board. Then unscrew the two M3×6 screws.
To Next Page
Loading...
