Mindray iPM-9800 - Disassembling the Interface Board Assembly

5-30
NOTE
z When reinstalling the batteries separator, aim the notch toward the error-proof
pillar.
5.6.7 Disassembling the Interface Board Assembly
1. Unscrew the two M3 nuts to take out the interface board outer support rack.
2. Take out the beryllium copper leaf and unscrew the four stud screws and one BNC nut
to take out the interface board inner support rack.
NOTE
z When reinstalling, the BNC nut installation sequence is washer, inner support
rack, washer, and BNC nut.
Beryllium
copper