5-8
5. Unscrew the four M3×8 screws and take the screen out carefully. Prevent the screen
from being contaminated or damaged. Clean the screen when reassembling.
NOTE
z When reassembling the front housing assembly, make sure you connect all the
cables in place.
z All the cables must be placed as shown below and fixed in the positioning buckle.
z Set the jumpers as follows. For single inverter, S13 is ON and S14 is OFF. For
double inverters, S13 is OFF and S14 is ON.
This cable must
be placed under
the touchscreen
board.
To Next Page
Loading...
