Minebea Intec MP 26 - Zero Setting

MP 26 Transmitter Installation and Calibration Manual
Minebea Intec
EN-16
Configuration
Depending on the device version and other configurations, the configuration data may be
hidden. The data that can be operated via the front panel are shown below:
3.7.2. Zero Setting
Zero setting is used to zero the scale. It deletes the display of accumulated deposits that could
falsify the measurement.
The zero set function is enabled through the configuration
(FuncFunc1 = 1).
Zero setting is achieved by
 Inputting a pulse [XXXX ms] on the digital input or
 Pressing a combination of keys or
 Setting a limit value
 Interface only (LOGIZErO)
For more details, please refer to Chapter 4.4: Zero Setting