MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 22
There are two ways to program the system.
1. By using *888 for Menu Driven type of programming.
2. By using the Direct Access Programming Codes for manual programming. Entering these codes will lead the user
directly to the desired function. The Direct Access Programming Codes are listed on the table below.
Code Function Factory Default Program Choices
*000 Exit Programming Mode *000 n/a NONE
*101 Enter Residents Dial Codes and Blank See worksheet 4 digit resident
Telephone Numbers code plus up to 8
digit telephone
number
*202 Review, Edit,Delete Codes & Blank See worksheet Up to 11 digits to
Names review or delete
*222 Enter Prefix (0) 0905 See worksheet 0-9 for the first
digit and up to 4
digits for area
code
*303 Enter Keyless Entry Codes Blank See worksheet 4 digits
*333 Quit Feature using the “#” key 11 __ __ 00 Press # key
once or
11 Press # key
twice (2 digits)
*404 Review , Delete Keyless Entry Blank See worksheet 4 digit code to
Codes review or delete
*444 Program On Line Timer for Minutes 00 __ __ 00 Seconds or
or Seconds 11Minutes (2
digits)
*505 Change Master Code *999 *__ __ __ 3 digits
*606 Select Pulse (Rotary) or Tone 11 Tone ___ ___ 00 Pulse or
(DTMF) 11 Tone (2 digits)
*707 Set Door Open Timer 10 seconds __ __ 00 to 99 seconds
seconds (2 digits)
*808 Set On Line Timer 60 seconds __ __ 00 to 99 (2 digits)
*909 Select MULTIPLE/SINGLE Entrance Single (11) __ __ 11 Single or
00 Multi (2 digits)
To Next Page
Loading...
Need help?
General
