MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 23
"NO MANUAL" MENU DRIVEN PROGRAMMING USING *888
While at programming mode, enter the "*888" to gain access to programming menu.
After entering the *888, the screen should appear...
[1=Bck] [3=Fwd]
Welcome to the ADC
On-Line Help Menu!
[*=Abort] [#=Yes]
1 and 3 keys are for scrolling backward or forward the feature menus.
# to access the displayed feature.
* to quit, exit, cancel, or abort.
Press 3 for next menu. The screen should appear...
[1=Bck] [3=Fwd]
Do you want to exit
from PROGRAM Mode?
[*=Abort] [#=Yes]
1 inactive key
3 key to the first feature menu.
# key to exit to Normal Mode.
* key to Programming Mode menu
NOTE: Repeat the above process to locate the desired feature.
To exit to Normal Mode, enter *000 while at PROGRAM MODE menu.
Press 3 again to first feature menu.
RESIDENTS’/TENANTS’ DIAL CODE and TELEPHONE NUMBER ENTRY
Residents'/Tenants’ Dial Codes can be entered in the format of 1, 2, 3, or 4 digits (less than 4 digits must be preceded
by 0's). These codes are used to call the Residents using the Entry Panel's keypad. The corresponding “telephone
number” for each dial code is set to 7-digits by default. ADC units will allow the user to define telephone numbers
up to 11-digits with 10 user definable 4-digit “Area Code” prefixes.
CAUTION! Before programming the system, the user must determine the maximum telephone number digit
length. Reformatting the telephone digit length will erase those programmed Dial Codes and
Telephone Numbers.
SETTING THE TELEPHONE NUMBER DIGIT LENGTH:
Scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to edit
Max. Digit/Listing?
[*=Abort] [#=Yes]
To Next Page
Loading...
Need help?
General
