Mircom ADC Series User Manual

MIRCOM TECHNOLOGIES LIMITED, ADC Series: Autodialer Telephone Access Systems Page 24
Press # to access the feature. The display should appear...
-Program Options-
Enter size as
07, 08 or 11 = _ _
Please enter choice:
Select: 07 for seven digits telephone numbers (factory default),
08 for eight digits telephone numbers, or
11 for eleven digits telephone numbers
* to abort entry and exit to PROGRAM MODE menu.
NOTE: When selecting 11digits, the user must use the 4-digit “Area Code” prefix to form up to an 11 digit telephone
number. There are ten user definable prefixes that can be assigned. Factory default for all the prefixes are
set to 0905. To assign a new prefix #, follow the instructions described under “TO CHANGE PREFIX
CODES” section below. Prefix numbers are not required for 7 or 8 digit telephone numbers.
After entering the choice for maximum digits per listing, the screen should change to...
-Program Options-
#=Store, *=Abort
07, 08 or 11 = x x
Please enter choice:
Press # to store or * to abort entry.
To quit, enter *000 while at PROGRAM MODE menu.
TO CHANGE THE PREFIX CODES:
To change the Prefix Codes, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to edit
Code and Prefix #?
[*=Abort] [#=Yes]
Press # to access the feature. The display should change to...
-Program Options-
Code Prefix # For Code: enter any number from 0 to 9
( _ ) _ _ _ _ For Prefix #: enter up to 4-digit “Area Code”
Please enter choice:
Where: “Code” (from 0 to 9) is used to call up the corresponding Prefix number.
“Prefix #” (up to 4 digits) is used for “Area Code” number that can be used with standard
7-digits telephone number to form up to 11 digits. Factory defaults for all 10 Prefixes are 0905.
Unused prefix digit(s) can be blanked-out by pressing the “#” key.
After entering the desired Code and Prefix #, the next screen should be...
-Program Options-
#=Store *=Abort
( x ) x x x x
Please enter choice:
Press # to store or * to abort entry. Repeat this process to edit or to assign new prefix numbers.
To exit to Normal Mode, enter *000 while at the PROGRAM MODE menu.

Mircom ADC Series Specifications

General

Brand	Mircom
Model	ADC Series
Category	Intercom System
Language	English