Mitel 1000 - Page 173

173
From the Programming extension, press the PROGRAM key.
Press the Scroll Down key (Ô) until “System Programming” is
displayed.
Select “System Programming”.
Enter the System Programming Password and select “System”.
Select “Remote Notification”.
Select “Outgoing group”.
Select the group.
Notification delay timer
The time interval between receiving a message and making the first
remote notification attempt is programmable. This is set at 15
minutes (900 seconds) in default and can be set between 1 and 30
minutes (60 - 1800 seconds).
From the Programming extension, press the PROGRAM key.
Press the Scroll Down key (Ô) until “System Programming” is
displayed.
Select “System Programming”.
Enter the System Programming Password and select “System”.
Select “Timers”.
Select “Notification Delay”.
Enter the value between 60 and 1800 seconds and press “Confirm”.
Notification interval timer
If a remote notification fails this is the time the system waits before
retrying the call. This is set at 5 minutes (900 seconds) in default.
The range is 1-15 minutes (60 - 900 seconds).
From the Programming extension, press the PROGRAM key.
Press the Scroll Down key (Ô) until “System Programming” is
displayed.
Select “System Programming”.
Enter the System Programming Password and select “System”.
Select “Timers”.
Select “Notification Interval”.
Enter the value between 60 and 900 seconds and press “Confirm”.
Call Recording
Those extensions allowed to record calls are set via system
programming.
From the Programming extension, press the PROGRAM key.
Press the Scroll Down key (Ô) until “System Programming” is
displayed.
Select “System Programming”.
Enter the System Programming Password and select ‘Extension’.
Scroll down and select ‘Call Recording’.
Select those extensions that are to be allowed record calls.
Voicemail Capacity
You change the message capacity of Mailboxes from the default of
20 messages per Mailbox to a higher or lower amount from 10 to 50
depending on demand.
From the Programming extension, press the PROGRAM key.
Press the Scroll Down key (Ô) until “System Programming” is
displayed.
Select “System Programming”.
Enter the System Programming Password and select ‘System’.