Mitel 700 - Page 64

Mitel 700 DECT Phone User Guide
56
Info Slowly flashing red LED for a new entry, in the call list.
Text messages Rapidly flashing red LED for a new text message.
Handsfree Lights green LED when the loudspeaker is activated.
Appointment Slowly flashing red LED when the appointment is signalled.
Alarm clock Slowly flashing red LED when the alarm time is signalled.
List access
The caller list and/or redial list are normally administered on your handset (setting: Local). If a
list is also managed in the communication system (setting: PBX), you can select which list you
want to display.
Select Automatic to ensure that the device always uses the list from the PBX communication
system (where available). If the list is not available, the automatic selection remains on Local.
Selecting PBX (or Automatic / PBX) makes sense if your handset is operating in parallel with
corded phones. This ensures that both devices have access to the same list and that any
changes made are visible on both devices.
Device options
Silent charging When this option is set, the DECT phone does not ring for
any calls when it is in the charger cradle. When you take it
out, calls are signalled acoustically signalled again. The
calls are recorded in the call list.
Silent charging does not apply when the handset is charged
using the USB connector.
Auto.key lock Can only be set when device is used on non SIP-DECT
system. If phone connected to SIP-DECT, auto key log can
be set in OMM only.
Charger answer If this feature is active, the DECT phone automatically
answers a call if it is taken out of the charger cradle.
Auto.answer (call) With this feature activated, the DECT phone answers a call
automatically. Activate this feature only if your work requires
it, as it is then possible for the caller to listen unnoticed.
For safety reasons, Auto answer is initiated using 3
attention tones, and its activation is signalled during the call
by the rapidly flashing green LED.
Press
Change to activate or deactivate.
You can set the following options:
Time: Sets the amount of time after which Auto answer
should be activated: 0-20 seconds. Note: If your device
supports the Text messaging and/or Paging features,
ensure that Time is set to a value greater than 3 seconds.
Mode: Allows you to select the auto answer mode
(Headset/Earpiece, Corded headset, Bluetooth, Charger
handsfree, Handsfree).
Microphone: Lets you answer the call automatically with or
without activated microphone. You can also activate the
microphone after the call using the softkey.
LED indication: Lets you activate or deactivate the LED
indication during the call.