Mitel 700 - Page 66

Mitel 700 DECT Phone User Guide
58
SOS number Enter the phone number to be called during an emergency call.
The SOS emergency number is dialed when you press the
SOS key (Mitel 722dt/732d/742d), a programmed emergency
key or by the Alarm sensor (provided no Alarm number is
programmed).
This menu item is not displayed if the SOS emergency number
is predefined by the system.
The SOS number can be set in OMM only. To set the SOS
number on the phone, the phone must be connected to a
non-SIP-DECT system.
DTMF tones cannot be transmitted in an active SOS call. This
is intentional and to prevent incorrect operation in the event of
an SOS.
SOS key Lets you specify how the SOS key (Mitel 722dt/732d/742d)
should respond. The emergency number is either dialed
immediately (SOS call: immediately) or only after you have
pressed the key a second time (SOS call: with confirmation) or
after you have pressed the key 3 times in short duration (3*
SOS Call: Press 3 times) or after you have pressed the key 5
times in short duration (5* SOS Call: Press 5 times)
Alarm sensor (Mitel 732d and 742d only)
Read the Alarm Sensor descriptions on “Alarm sensor (Mitel 732d and 742d only)” on
page 29 before changing the settings.
Alarm number This menu item is not displayed if the SOS emergency number
is predefined by the system. Enter the alarm number to be
called in the event of a sensor alarm.
You can precede the call number with the R key function
(inquiry) by pressing the # key three times; the alarm call is
then also possible during a call (depending on the system and
the handset).
Alarm auto answer You can specify whether a call from any call number should be
answered automatically during the pre-alarm. Regardless of
the setting, calls from the alarm number or SOS emergency
number are answered automatically and the pre-alarm is
terminated.
Handsfree in alarm The DECT phone is switched to hands-free mode when the
SOS emergency number is dialed.
Pre-alarm Use Change
to switch the pre-alarm on and off for all alarm
types.
Alarm tone: The pre-alarm can be sounded with or without an
alarm tone on the handset. If the alarm tone is activated, the
signalling volume increases progressively.
Vibrator: You can set whether the pre-alarm should also be
signalled with vibrator call.
Duration: You can set the time (10-75 seconds) that should
elapse before the emergency number is dialed. An
increasingly loud ring tone (alarm tone) is signalled on the
handset during this time (provided it is activated). The alarm
can still be cancelled during the pre-alarm phase.