Mitsubishi Electric CR800-D Series - Page 43

Startup and initial settings 41
(5) Adjust display points on the graph.
1) Change "Display Points" on the lower right side of the Oscillograph screen.
2) When you move the slider on the bottom to the right direction, the value on the right side changes.
Display points are points to be displayed on graph.
Example) When you set the display points to "Time scale (10minutes)", the data created for 10 minutes
is displayed on the graph.
*Since the score (reduction gear) changes slowly, by setting "Time scale (10minutes)" for the display points,
it is easy to check convergence of the score value.
1) Select "Display Points"
Example) Time scale
(10minutes)
Example) Displaying 10-min data on 1 screen
2) When you move the slider on the bottom
to the right direction, the value changes
to 60,000[msec] (10minutes).